Intake manifold for Yamaha Virago XV 750 1000 1100, rear cylinder

Irregular engine running at idle usually indicates old, hardened or brittle intake manifolds.

DESCRIPTION:
The engine draws false air and therefore runs noticeably lean. In the worst case, the engine could run hot and, in the case of extreme air leakage, even various cost-intensive defects could occur. It must not come so far.
With our intake manifolds in OEM quality, you do everything right. This intake manifold is equipped with 2 vacuum connections and can therefore also be used for the Japanese and US version of the Yamaha XV 1000 with the split tank and mechanical vacuum fuel tap. For the European version with the electric fuel tap, the right of the two connections is not needed and is therefore equipped with a cap.
Note:
The intake ports of the front and rear cylinders are almost identical, but differ slightly in angle. Therefore it is essential to pay attention to the correct assignment (2 open ports at the front - 1 open port at the rear) during installation, otherwise the carburettor battery is very difficult to insert and draws false air.

TECHNICAL DATA:
- for the rear cylinder
- replaces original part Yamaha OE 24M-13586-01
- incl. seal
- Passage: 38mm
- Carburettor connection: 47mm
- Hole distance "hole centre to hole centre": 76mm

SCOPE OF DELIVERY:
✔ 1x intake manifold for rear cylinder(new)

FIT FOR:
YAMAHA
XV 1000 SE Midnight Special (23W), BJ 1983-1985
XV 1000 Virago (2AE), FY 1986-1988
XV 750 Virago (4FY), FY 1992-1994
XV 750 Virago (4PW), FY 1995-1997
XV 1100 SP Virago (3LP), year 1996-1999